Monday, February 16, 2015

How to set an internal boundary condition in SWMM 5, InfoSWMM and H2OMap SWMM

How to set an internal boundary condition in SWMM 5, InfoSWMM and H2OMap SWMM
  1. Make the internal boundary node a storage node
  2. Set the Storage node initial depth
  3. Give it a large storage area
  4. Set the offset depth of the link below the storage node to the Storage Node initial depth
  5. The Node depth will be at the initial depth at the start of the simulation
Internal Boundary Node in SWMM 5 at a fixed depth.                Internal Boundary Node in SWMM 5 at a fixed depth.

No comments:

Low Impact Development Control Editor in InfoSWMM based on SWMM5

Low Impact Development Control Editor The  LID Control Editor  is used to define a low impact development control that can be depl...