Dry Weather Flow in InfoSWMM
Dry weather flow can be added to any node in H2OMAP SWMM. The dry weather flow is computed as the average flow * the monthly pattern * the daily pattern * hourly pattern * the weekend daily pattern to give the Dry Weather Flow at any time step (Figure 1). Since the four types of patterns (Figure 2) are all multiplied together then for and the hourly pattern and the weekend hourly pattern will both be used. This will have the effect of overestimating the flow if the multipliers are greater than 1 and underestimating theflow if the multipliers are less than one. You should enter the Pattern X for the Weekend Hourly Pattern in H2OMAP SWMM where
X = Weekend Hourly Pattern / Hourly Pattern
So that when the pattern X is multiplied by the Hourly Pattern the program will use the intended Weekend Pattern.
Figure 1. How Dry Weather Flow is Computed in H2OMAP SWMM
Figure 2. The Four Types of Time Patterns in H2OMAP SWMM, InfoSWMM and S
Thursday, November 1, 2012
Weekend DWF Patterns in H2OMAP SWMM and InfoSWMM
Dry Weather Flow in InfoSWMM and H2OMap SWMM
GIS Gateway – Create Shapefile T he Create Shapefile tool available from the GIS Gateway , allows you to create a new ESRI® Shapefile dir...
Engine Error Number Description ERROR 101: memory allocation error. ...
Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e...
Soffit Level ( pipe technology ) The top point of the inside open section of a pipe or box conduit. The soffit is the ...