Subject: How to Have both Depth and Elevati
If you turn on store Absolute Junction Rim option then the Rim Elevation = Invert Elevation + Maximum Node Depth will be shown in the DB Table Junction Hydraulic Modeling Data and the Attribute Browser of InfoSWMM and H2OMAP SWMM
Figure 1. Store Absolute Junction Rim Elevation Option
Now the Rim Elevation can be copied from the DB Table
Figure 2. The DB for Junction Modeling Data
And Pasted to the Elevation Table in Junction Information
Figure 3. The DB for the Junction Information Data
Then you can go back and turn off the Preferences flag and you will have the Rim Elevation in in the Information Table and the Maximum Depth in the Junction Hydraulic Modeling Data DB Table, I do this all of the time as it helps to see both the depth and the Elevation.
Saturday, October 20, 2012
How to Have both Depth and Elevation for the Node Rim Elevation in InfoSWMM
Subject: How to Have both Depth and Elevation for the Node Rim Elevation in InfoSWMM
GIS Gateway – Create Shapefile T he Create Shapefile tool available from the GIS Gateway , allows you to create a new ESRI® Shapefile dir...
Engine Error Number Description ERROR 101: memory allocation error. ...
Soffit Level ( pipe technology ) The top point of the inside open section of a pipe or box conduit. The soffit is the ...
Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e...