Use the SWMM 5 Scatter Graph to show the Pump Curve used during the Simulation

Subject:  Use the SWMM 5 Scatter Graph to show the Pump Curve used during the Simulation

Use the SWMM 5 Scatter Graph to show the Pump Curve used during the Simulation

by dickinsonre
Subject:  Use the SWMM 5 Scatter Graph to show the Pump Curve used during the Simulation 
You can use a scatter graph to show the relationship between the pump during the simulation and the Storage Depth.   If the pump is on the curve based on the pump summary table then the scatter graph should  look like the pump curve.  The pump summary table in the  SWMM 5 RPT also shows you the time off the pump curve low and high.
 

Comments

Popular posts from this blog

Soffit Level

Water Analogies for Divergence, Curl and Gradient

SWMM 5 Error Messages