Subject: SWMM 5 will iterate for the new node depth at each time for a minimum of 2 iterations to a maximum of 8 iterations based on the Node Continuity equation. If you plot the average number of iterations over time then typically the number of iterations go up as the Inflow increases. The nodes with the most iterations changes over time as the peak flow moves through the network as shown in this plan view. The iterations used during the simulation is a function of the node stop tolerance which has a default value of 0.005 feet in SWMM 5.
Stormwater Management Model (SWMM) Information for watershed water quality, hydrology and hydraulics modelers (Note this Blog is not associated with the EPA). You will find Blog Posts and Twitter Embeds on the Subjects of SWMM5, InfoSWMM, InfoSewer, ICM SWMM Networks, SWMM4 and SWMM in general.
Subscribe to:
Post Comments (Atom)
HOW TO USE GIS GATEWAY IN INFOSWMM TO CREATE BOTH DATA AND MODEL RESULTS SHAPEFILES
GIS Gateway – Create Shapefile T he Create Shapefile tool available from the GIS Gateway , allows you to create a new ESRI® Shapefile dir...

-
Engine Error Number Description ERROR 101: memory allocation error. ...
-
Subject: Manhole Elevations in InfoSWMM and SWMM 5 Starting from the bottom of the manhole you have these regions of compu...
-
Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e...
No comments:
Post a Comment